Satec PM135 Quick Start Manuel d'utilisateur télécharger pdf

BG0517 REV.A1 ENGLISH PM135 QuickStart www.satec-global.com

PM135 Quick Start Manual

This quick start manual is a short guide on how to mount, connect, configure and operate the

PM135. It is not intended to replace reading the full user manual and particularly the safety

precautions.

Mounting, electrical connection and settings of the PM135 shall be made in

accordance with all applicable laws and/or regulations and be performed by

authorized personnel only.

MOUNTING

Position the PM135 meter in 92×92mm square or 4” round cutout (Figure 1). If two PM135 are

positioned side by side, keep at least 150mm (5.9”) between their centers to allow installation

of add-on modules (140mm/5.5” if only small form modules will be used).

Attach the PM135 unit using washers and nuts. Make sure that the unit is securely attached

into the wall or cabinet fixture.

Figure 1

Win a

Tablet!

See back page

1 2 3 4

BG0517 REV.A1 ENGLISH PM135 QuickStart www.satec-global.com PM135 Quick Start Manual This quick start manual is a short guide on how to mount, conn

PM135 QuickStart www.satec-global.com CONNECTION To connect follow these steps (Figure 2 shows a 4W LV installation with conventional CTs): 1. Ensu

PM135 QuickStart www.satec-global.com OPERATION The PM135 is operated using the front panel which consists of an LCD display, 12 LEDs and five key

Page 4

PM135 QuickStart www.satec-global.com CONFIGURATION The essential configuration includes: 1. Basic measurement setup 2. Communication setup and t

Pas de commentaire

Satec PM135 Quick Start Manuel d'utilisateur